Executing a First Load Test
You can now execute a first try of the load test if your recorded Web surfing session does not contain dynamically exchanged session parameters. What follows is only a short overview.
Step
Screenshot
Now, the load test program can be started. Apica recommends choosing only a few numbers of simulated users and a short execution time for the first test run
Press Continue to go to the final Confirmation page
Example Analysis
We are seeing the same failed URL errors during the load tests, on the same page and on the same URL.
Tip: Likewise: If your load test fails and a permanent error occurs at the same URL and this is a variable, you should call the Var Finder menu – and verify if the handling for dynamically exchanged session parameters must be applied.
In these cases, we strongly recommend reading the installed ZT manual about Handling "Dynamically-Exchanged Session Parameters" (Attached)
Was this helpful?